Cart
← Back to Product Catalog

Glensound – Beatrice D8

Intercoms

More details

Similar Products

delec-dante-desk16-crop|delec-dante-desk16-crop
  • DELEC

DELEC – Desk 16 Dante

The DELEC Desk 16 Dante is a 16-key desktop subscriber panel equipped with a Dante interface so it can be connected directly to a Dante network without the need for an additional convertor. These units can be hooked up to any DELEC intercom unit equipped with a Dante interface, e.g. CS 1624. These new subscriber panel models allow operators to target specific addresses or – using DELEC NAMs – announcement speakers. All three models come with Dante Primary and Secondary ports for fully redundant operation. In a different scenario, these two ports can be used to daisy-chain several subscriber panels, reducing cabling requirements dramatically. As a result, these new subscriber panels are not only perfect for broadcast and theatre environments but also for any application which requires long cable runs.
    Intercoms
See the product
glensound-gs-fw012-ip_600px|glensound-gs-fw012-ip_600px
  • Glensound

Glensound – GS-FW012 ip

The GS-FW012 ip is the Dante network audio version of the GS-FW012 4W unit. The GS-FW012 ip is the Dante network audio version of the GS-FW012 4W unit.   There are still four inputs for the top panel loudspeaker or headphone monitoring, each with their own level controls and each being derived from the Dante network.  There are still four talkback outputs each being routed to the Dante network. Both the inputs and outputs are presented via a single rear panel Neutricon RJ45/CAT5 connection that is Dante/AES67 compliant. The four talkback outputs are identical.  Each has a 3 position lever key talk switch that is either off, locked on, or in a sprung push to talk mode.  The output of each circuit can be off unless the talkback button is pressed, looping the the associated Dante input input, or outputting the local cue input. The local cue input is presented on XLR and has it's own level pot for the speaker or headphone monitoring. A good quality microphone amplifier with adjustable gain followed by a compressor limiter is built into the unit making its talkback outputs to the Dante network crystal clear. Conversion of the audio signals to/ from the Dante network are by low noise, high bandwidth 48K 24bit converters providing superb performance.  
    Intercoms
See the product
q_attero_tech_Zip4_3G_front
  • Attero Tech by Q-SYS

Attero Tech by Q-SYS – Zip 4-3G

The Zip4-3G four-zone Dante/AES67 paging interface addresses the unique communications needs of large sporting venues, transit hubs like airport terminals and train stations, as well as convention centers and corporate facilities. Paging audio and bi-directional control and status data can be routed over a Dante or AES67 network to the Q-SYS Ecosystem, third-party network AV system or other Paging Management System controller to distribute paging audio to up to four different zones. Finally, it allows for a gooseneck paging microphone.

    Intercoms
  • AES67 Enabled
See the product