Cart
← Back to Product Catalog

Kling & Freitag – D 10:4

Amplifiers

More details

Similar Products

ne_60186601_dsp7101nrr_dv10
  • Extron Electronics

Extron – NetPA U 8001 SUB

The Extron NetPA U 8001 SUB is an ENERGY STAR qualified subwoofer amplifier that delivers 800 watts in a half rack, 1U, plenum rated enclosure. Dante Domain Manager and AES67 support ensure wide compatibility with enterprise configurations and other network audio devices. With its integrated DSP for essential processing, frequency range optimized for subwoofers from 20 Hz to 1 kHz, the NetPA U 8001 SUB amplifier is the perfect companion to the Extron SF 10C SUB subwoofer. This powerful combination meets the requirements of complex, decentralized systems with a complete space-saving solution.

    Amplifiers
  • Dante Ch: 2x2
  • 24-bit
See the product
CMX - Power amplifier with DSP & Dante
  • CMX

CMX – DSP-4350

The CMX DSP-4350 is a power amplifier with DSP and Dante.

  • 4 x 60W power amplifier
  • 100V, 70V, 4 Ohm & 8 Ohm output with selectors
  • Built-in DSP with EQ, gain control, crossover, delay, limiter, high-pass filter & low-cut filter
  • Dante network control with 4 In 4 Out matrix
  • Two Ethernet RJ-45 network connector for both Dante and DSP configure
  • Remote GPIO for failure outputs
  • 1U height 19” rack mount type power amplifier
  • Balanced line input by phoenix connector for four channels.
  • Each four inputs with separate gain control.
  • Separate four channel indicators for protection, clip, input and output.
  • Complete short circuit, overload, high temp, clip and DC protection.
  • Dante increases connectivity flexibility, and provides the freedom to use the amplifier power away from the source, wherever it is needed. It also enables the models to allow mixed inputs using either digital or onboard analog audio connections
    Amplifiers
See the product
ashly-nXe-8002_600px|ashly-nXe-8002_600px
  • Ashly Audio

Ashly – nXe8002bd

The nXe8002bd is a 2 channel multi-mode amplifier capable of driving 2 Ohm loads at full power. The maximum rated output power is 800W per channel at Low Z, 70V, and 100V mode. There is an automatic but defeatable sleep mode consuming <1W, and instant standby mode controlled by contact closure or software. A switch mode power supply auto-detects 120VAC or 240VAC mains, and a Neutrik® powerCON is used for the AC cord. Each channel has selectable output mode of Low Z, 70V, or 100V, an 80Hz high-pass filter, input limiter, and input gain settings of 26dB, 32dB, 38dB, or 1.4V. Each channel has remote DC level control. Input connectors are Neutrik® XLR/TRS combo jack and Euroblock, while output connectors are Neutrik® speakON. The unit has a front panel power switch and level controls that can be disabled. LEDs indicate Protect, Sleep, Disabled, Com, and Bridge mode status, as well as Temperature, Output Current, Output Signal, and Clipping/Mute status per channel. The unit has Ethernet control with a real-time clock for event scheduling. The unit has serial data remote control, aux preamp outputs, preset control, fault condition logic outputs, optional network audio and AES3 digital audio capability. The amplifier has temperature dependent variable speed forced-air cooling.
    Amplifiers
See the product