Product Information
The Topp Pro RTDLM808 is an 8×8 digital matrix with gating, compression, expansion, delay, and crossover capabilities.
Specifications
- Dante Ch: 8x8
- Bit Depth: 24-bit
- Sample Rate: 48kHz
Topp Pro – RTDLM808
Similar Products
- Lynx Studio Technology
Lynx Studio Technology – Aurora (n) 32-DNT
The Aurora (n) 32-DNT provides you with pro-quality digital conversion and ultra-low-latency performance.
The Aurora (n) 32-DNT provides you with pro-quality digital conversion and ultra-low-latency performance. The Aurora (n) 32-DNT gives you up to 192kHz analog to digital and digital to analog conversion with front panel control of all routing and sample rate options. Word clock and MIDI I/O connectors provide you with additional sync options, and the preinstalled LT-DNT Dante card gives you maximum networking bandwidth, with minimal latency. Aurora (n) models give you up to 32-channel recording and playback to microSD for stand-alone operation or confidence recording, as well as two audiophile-grade headphone outs, while a TFT LCD display provides immediate status information. Leveraging high-end Lynx Hilo technology and utilizing cutting-edge FPGA processors, Aurora (n) delivers even greater transparency, with significantly lower noise and distortion than previous models.
- I/O Interfaces
- Dante Ch: 32x32
- 24-bit
- DiGiCo
DiGiCo – Dante A164D WALL LCD
The A164D Wall LCD is a 16 input 4 output I/O Expander that uses the Dante network protocol to provide fixed, additional I/O anywhere on a network and is designed for wall or floor mounting. It comes with 16 Mic Preamps on XLR inputs with Phantom Power status LEDs and four XLR Line Outs with direct preamp control from the 4REA4 controller software. It can run at both 48K and 96k sample rates and it is AES67 compatible. Primary and secondary Dante ports come with locking EtherCON connectors and can run in both redundant and switched mode. All LCD labels are dimmable and can be customised using Dante controller software.
- I/O Interfaces
- Dante Ch: 16 In
- 24-bit
- Mansion
Mansion – DIT2E13A
DIT2E13A is a high quality Dante interface box for converting Analogue Audio inputs to Dante channels.
DIT2E13A is a high quality Dante interface box for converting Analogue Audio inputs to Dante channels.
Features
- Dante Interface for Audio Output
- Terminal Block Input Jack on front panel
- Converts Line Audio Signal to Dante Network
- Input Gain Control on front panel
- Dante Sample Rates Support: 44.1, 48, 88.2, 96KHz
- High Resolution Analog to Digital Conversion
- Power over Ethernet (PoE)
- Excellent Audio quality
- I/O Interfaces