DiGiCo - A168D Stage

DiGiCo – A168D Stage

Product Information

The A168D Stage is a portable 16 input 8 output I/O Expander, again using the Dante network protocol to provide additional I/O anywhere on a network. It comes with 16 mic preamps on XLR inputs with Phantom Power status LEDs and 8 XLR line outputs with direct preamp control from the 4REA4 controller software. It runs at 48k and 96k and is AES67 compatible. Primary and secondary ports again come with locking EtherCON connectors and can run in redundant or switched mode.

Specifications

Dante Ch: 16x8
Bit Depth: 24-bit
Sample Rate: 48kHz, 96kHz
AES67 Enabled

RME – 12Mic-D

The RME 12Mic-D features twelve microphone and line level inputs with digital, no-compromise, studio-quality conversion; remote controllable gains; integrated MADI and Dante connectivity; plus a multitude of additional functionality, designed for use in high-end studio recording, live audio, and location sound and music recording.

I/O Interfaces

See the product

Alfatron Electronics

ALF-DAI-2XLR

The ALF-DAI-2XLR 2 channel analog to Dante input adapter is a complete high-performance Dante device with the automation and ease-of-use features that make Dante the world’s most popular audio networking solution. The ALF-DAI-2XLR Adapter is compatible with all Dante interfaces and provides all the features you would expect from a Dante audio network. It is capable of providing high-fidelity audio reproduction, ultra-low latency, and sample-accurate synchronization across the entire network. Features:

Seamlessly integrate Dante systems into traditional analog systems.
There is no need to discard familiar mixing consoles, wireless microphones, and other analog signal sources, or analog amplifiers. All you need is to incorporate them into your audio network via Dante I/O.
With 2 channels of analog input on XLR
POE(802.3af)

I/O Interfaces

Dante Ch: 2 Out
24-bit

See the product

Extron Electronics

Extron – AXI 44 AT

The Extron AXI 44 AT is a quarter rack width audio interface for integrating four mic/line sources onto a Dante™-enabled audio system. The Extron AXI 44 AT is a quarter rack width audio interface for integrating four mic/line sources onto a Dante™-enabled audio system. It features four mic or line inputs on 3.5 mm captive screw connectors, with switchable 48 volt phantom power. Input select, gain, and phantom power settings are controllable from the front panel, via DSP Configurator Software, or by SIS command. The AXI 44 AT also features four line level outputs for routing any four Dante channels from the network to the audio system. The AXI 44 AT interfaces with any Dante-equipped audio processor, and can be powered via PoE.

I/O Interfaces

Dante Ch: 4x4
24-bit

See the product

DiGiCo – A168D Stage

Product Information

Specifications

Similar Products

RME – 12Mic-D

ALF-DAI-2XLR

Extron – AXI 44 AT

Stay connected to Dante

Support

Company

Dante Networking Alliance