Cart
← Back to Product Catalog

Blustream – DA22XLR-WP-EU

I/O Interfaces

Learn more

Similar Products

danacoid
  • Danacoid

Danacoid – DN-210RXC

Video: HDMI v2.0 and HDCP 2.0

Supported resolution: 4096 x 2160 /60P (4:4:4)；

Supports wiring of up to 8 HDMI embedded LPCM digital audio channels, as well as 24bit,192kHz sampling frequency for each sample.

Supports transmission of embedded HBR audio formats: such as Dolby digital true HD and DTS-HD Master Audio.

IP network-based audio, supports transmission of network-based audio via switches

2 * USB ports, supports KVM function

IR Control: Supports bidirectional IR transmission

RS-232 Control: supports bidirectional RS-232 transmission, up to 115,200 baud

HDMI input 1 * 19-pin female HDMI interface

Analog stereo audio: 1 * 3.5mm stereo-mini jack

10GbE and 1GbE ports: 2 * shielding RJ45 interface and LED indicator light

1 * IR input: 3.5mm stereo mini jack

Maximum pixel clock frequency: supports pixel clock frequency up to 594MHz

Switching Plane: independent switching planes supported I/O switch arrays of all connected videos, audios, RS-232 and IR signals

    I/O Interfaces
See the product
a168dstage
  • DiGiCo

DiGiCo – A168D Stage

The A168D Stage is a portable 16 input 8 output I/O Expander, again using the Dante network protocol to provide additional I/O anywhere on a network. It comes with 16 mic preamps on XLR inputs with Phantom Power status LEDs and 8 XLR line outputs with direct preamp control from the 4REA4 controller software. It runs at 48k and 96k and is AES67 compatible. Primary and secondary ports again come with locking EtherCON connectors and can run in redundant or switched mode.

    I/O Interfaces
  • Dante Ch: 16x8
  • 24-bit
See the product
ctp-systems-DIO88|ctp-systems-DIO88
  • CTP Systems

CTP Systems – DIO88

The DIO88 is an inexpensive way to get your analogue signals into and out of the Dante network. The unit has eight XLR inputs and eight XLR outputs. The secondary Dante network connector can be selected to operate either in redundant mode or as a switch output to daisy chain more Dante equipped devices. The DIO88 is an inexpensive way to get your analogue signals into and out of the Dante network. The unit has eight XLR inputs and eight XLR outputs. The secondary Dante network connector can be selected to operate either in redundant mode or as a switch output to daisy chain more Dante equipped devices. The init includes a power indicator and network connection indication on the RJ45 jacks. 
    I/O Interfaces
See the product